Enfora GSM2228UG001 ユーザーズマニュアル

 

GSM2228UG001                                                                                                            Page 15 

 

 
The Mini-MT must be configured before use.  Configuration is performed through AT 
commands from a PC computer.  A terminal program is required to interface to the Mini-
MT through the USB cable.   
 
The drivers for the Mini-MT support Windows XP and Windows 2000 operating 
systems.  While Enfora uses HyperTerminal to configure the Mini-MT, the user can use 
another terminal program.  
 
The Mini-MT drivers must be installed on your computer before proceeding.  Refer to 
Section 8: PC Software Installation of this document for driver installation. 
 

 
The “Dispatch Number” is the phone number the Mini-MT will call when the Push-To-
Call (PTC) button is pressed. 
 
To configure the Mini-MT to call phone number “1-214-555-1212” enter the following 
command: 
 

AT$DSPATCH=“12145551212” <Enter> 
 

After entering the dispatch number enter:  AT&W <Enter> to save.  This will ensure that 
if the battery is removed the number will not need to be re-entered. 
 

 
The SMS Destination Address is where the Mini-MT would send an SMS text message.  
The Mini-MT can store up to five (5) SMS Destination Addresses.  The following 
example shows how to set an SMS Destination Address: 
 

AT$SMSDA=1, “19875551212”<Enter>