West Elm Antler Wall Shelf 組み立て手順
mounting instructions
: antler wall shelf
5626536 - 02/08
page 1 of 1
drywall toggle anchor 2x
screw 2x
A
B
1.
2. Using a Philip's head screwdriver, insert the drywall anchors (A)
into the wall at the insertion points. Press and turn clockwise
until anchors are flush with the wall.
into the wall at the insertion points. Press and turn clockwise
until anchors are flush with the wall.
3. Insert screws (B) into the anchors or at the insertion points, leaving
approximately 1/4" between the back of the screw head and the wall.
approximately 1/4" between the back of the screw head and the wall.
4. Align keyhole notches over the screw heads.
5. Slide the shelf down until it rests on the screws. Tighten or loosen
screws as needed to fit the shelf snugly against the wall.
screws as needed to fit the shelf snugly against the wall.
NOTE:
• For your safety, installation by two people is recommended.
• Maximum load on shelf is 40 lbs
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
• For your safety, installation by two people is recommended.
• Maximum load on shelf is 40 lbs
• Wipe with a soft, dry cloth. To protect the finish, avoid
the use of all chemicals and household cleaners.
Tape the enclosed template to the wall at the desired location.
Use a carpenter’s level to insure the lines of the template are
level. With a tack or nail, poke through the template into the
wall at the cross-marks. These holes will be the insertion points
for the hardware. Remove the template.
Use a carpenter’s level to insure the lines of the template are
level. With a tack or nail, poke through the template into the
wall at the cross-marks. These holes will be the insertion points
for the hardware. Remove the template.
A
B
paper template 1x
C
A
B
Screw head 1/4”
out from wall
out from wall
Flush with wall