Weslo WLEX60071 オーナーマニュアル

As you pedal, there should be a slight bend in your
knees when the pedals are at the lowest position. To
adjust the seat, first hold the seat and unscrew the
seat knob. Align one of the holes in the seat post with
the hole in the frame. Insert the seat knob into the
frame and the seat post, and tighten the seat knob
into the frame. Make sure to insert the seat knob
through one of the holes in the seat post; do not
insert the seat knob under the seat post. 

If the exercise
bike does not
rest evenly on
the floor, the
problem may
be corrected
with the
adjustable caps
on the front
stabilizer.
Rotate one or
both caps until
the exercise
bike rests evenly on the floor.

The electronic monitor features five modes that pro-
vide instant exercise feedback during your workouts.
The modes are described below.

¥ SpeedÑDisplays your speed, in miles per hour.

¥ TimeÑDisplays the length of time you have exer-

cised. Note: If you stop pedaling for ten seconds or
longer, the time mode will pause until you resume.

¥ DistanceÑDisplays the total distance you have ped-

aled, in miles.

¥ CalorieÑDisplays the approximate number of

Calories you have burned.   

¥ ScanÑDisplays the speed, time, distance, and calo-

rie modes, for 5 seconds each, in a repeating cycle.

Before the electronic monitor can be operated, two
ÒAAÓ batteries must be installed. If you have not
installed batteries, see assembly step 5 on page 5. 

Front Stabilizer

Adjustable Cap

1. To turn on the power, press the on/reset button or

simply begin pedaling. When the power is turned
on, the entire display will appear for two seconds.
The electronic monitor will then be ready for opera-
tion.  

2. Select one of the five modes:

Scan modeÑ
When the
power is
turned on, the
scan mode will
automatically
be selected.
One mode
indicator will
show that the
scan mode is selected, and a flashing mode indica-
tor will show which mode is currently displayed.
Note: If a different mode is selected, you can select
the scan mode again by repeatedly pressing the
mode button.

Speed, time,
distance or
calorie
modeÑTo
select one of
these modes
for continu-
ous display,
press the
mode button
repeatedly. The mode indicators will show which
mode is selected. (Make sure that the scan mode is
not selected.)   

3. To reset the display, press the on/reset button.

4. To turn off the power, simply wait for about four min-

utes. Note: The monitor has an Òauto-offÓ fea-
ture. If the pedals are not moved and the moni-
tor buttons are not pressed for four minutes,
the power will turn off automatically in order to
conserve the batteries. 

Mode
Indicators

Display

Seat Knob

Seat Post

Seat 

Frame