Whirlpool 3191799 ユーザーズマニュアル

Make electrical connection following the 

steps needed for your installation.
1. Disconnect the power supply.
2. Remove the junction box cover.
3. Connect range cable to junction box through

the U.L.-listed conduit connector. 

4. Connect the two black wires together with

twist-on connectors.

5. Connect the two red wires together with 

twist-on connectors. 

6. Complete electrical connection according to

local codes and ordinances.

7. Connect the factory-crimped

bare and white range cable
wires to the neutral (white) wire
in junction box. See Figure 1.

8. Replace junction box cover.

7. Separate the factory-crimped

bare and white range cable
wires.

8. Connect white range cable wire

to neutral (white) wire in
junction box. See Figure 2.

9. Connect the bare ground range

cable wire to a grounded wire in
the junction box. See Figure 2.

10. Replace junction box cover.

7. Separate factory-crimped bare

and white range cable wires.

8. Connect white range cable wire

to neutral (white) wire in
junction box.  See Figure 2.

9. Connect the bare ground  range

cable wire to the green ground
wire in junction box. Do Not
connect bare ground wire to
neutral (white) wire in junction
box. See Figure 2.

10. Replace junction box cover.

Turn on power supply. The display

panel will light up briefly. “PF” should appear in
the temperature display.

Lift range into cabinet cutout using the

oven opening as an area to grip. Be careful not to
damage countertop.

To avoid damaging the countertop, lift range
slightly while pushing against seal area of front
frame. Push range into cabinet cutout until
shipping feet almost contact cabinet. Use a
Phillips screwdriver to remove screws attaching
shipping feet. Remove and discard shipping
feet.
Push range completely into cabinet and center
range in cabinet cutout. Be careful not to
damage countertop.

Replace the oven door by inserting ends 

of hinges into hinge slots in range frame. Push
behind each hinge so that hinges are pushed into
range frame as far as they will go. Open door and
remove both door removal pins. Close and open
door to check that door closes and opens
completely. If door does not close or open
completely, you have not pushed hinges
completely into frame. Repeat door removal step
and reinsert door into hinge slots again.

Important: Securely fasten range to cabinet

using the two screws provided. Insert the screws
through holes in mounting rails. Do Not
overtighten screws.

Slide top end of each trim upward onto

range side rails. Push each trim into place at
bottom of trim. Use screws to attach each trim to
range. Take care not to scratch other surfaces with
ends of trim.

elements. Push in and turn each surface unit
control knob to “HI” position. Check the operation
of the cooktop elements and indicator lights.

Replace oven racks. 

element. Press the “BROIL” pad. “BROIL” will
appear in the display. Press the “START” pad.
Make sure the oven door is closed and the “ON”
light is shown in the display area. After 2
minutes, partially open oven door.  You should
feel heat from the oven. Press the “CANCEL” pad.
If your oven does not heat or an “F”, followed by
a number, appears in the display, contact your
dealer or check the “If you need service...”
section of this Installation Instructions.