Wayne-Dalton 9600 ユーザーズマニュアル

Tools Needed:

Tools Needed:

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 

local yellow pages/business listings or go to the 

Find a Dealer section online at www.Wayne-Dalton.com

Install the side lock on the second 
section of the door. secure the lock to 
the section with (4) 1/4”- 20 x 11/16” 
self drilling screws. square the lock 
assembly with the door section and 
align with the square hole in the vertical 
track. The side lock should be spaced 
approximately 1/8” from the section 
edge.

IMPORTANT: sIDE lOCks MusT BE 

REMOVED OR MaDE INOPERaTIVE IN 

THE uNlOCkED POsITION If aN 

OPERaTOR Is INsTallED ON THE DOOR.

NOTE: after completing this step, 

continue with step 9 on page 15.

❉

(4) 1/4”- 20 x 11/16” 

sElf DRIllING sCREWs

1/8”

Power Drill

7/16” socket 

Driver

NOTE: When installing a DoorMaster

TM

 

operator use the center bracket and 

drive gear supplied with your operator 

(located in DoorMaster

TM

 package). 

slide the DoorMaster

TM 

bracket/drive 

gear assembly onto the TorqueMaster

®

 

spring tube, so that the drive gear/center 

bracket assembly are in the center of 

the TorqueMaster

®

 spring tube. 

NOTE: after completing this step, 

continue with step 20 on page 22.

None

❉

CENTER 

BRaCkET 

BusHING 

assEMBly

TORquEMasTER

®

 TuBE

DOORMasTER

TM 

 BRaCkET/ 

DRIVE GEaR assEMBly 

To locate the center bracket, mark the 
header halfway between the flagangles 
and level the TorqueMaster

®

 spring tube. 

Drill 1/8” pilot holes into header for the 
lag screws. fasten the metal bracket to 
the header using (2) 1/4” x 1-1/2” lag 
screws.

NOTE: after completing this step, 

continue with step 29 on page 28.

Tools Needed:

Power Drill

1/8” Drill Bit

7/16” socket 

Driver

(2) 1/4” x 1-1/2” 

HEx HEaD laG 

sCREWs