Brother PS-300B オーナーマニュアル

BAS-311E.311EL.326E.326EL

■ (Y axis) 311E and 311EL

1. Remove the belt cover 

q and the frame side cover w.

2. Connect the programmer to the operation panel.
3. Turn on the power of the machine.
4. Press the P key on the programmer.

5. Attach the needle 

e.

6. Turn the pulley to approach the needle 

e to the H-posi-

tion standard plate 

r.

7. Press the P key and adjust the Y-home position dog 

t so that the needle e is aligned with the home position (X=0, Y=0)

of the H-position standard plate 

r.

8. Press the P key again to make sure that the needle 

e is aligned with the home position (X=0, Y=0) of the H-position

standard plate 

r.

9. Secure the Y-home position dog 

t using the set screw y.

10.Remove the needle 

e.

11.Press the P key to be out of the program mode, and turn off the power.
12.Replace the H-position standard plate 

r with the work clamp.

Note: When adjusting the Y home position, be sure to set the clearance between the Y-home position dog 

t and the

surface where the sensor 

u is activated to 0.1 - 0.5 mm.  If the clearance is too great, an error in home position

detection may occur because the temperature of the sewing machine rises during sewing operation.

q

w

e

r

e

r

t

u

y

u

0.1 - 0.5mm

t

H - position
(X = 0, Y = 0)