Worth Data 802 RF ユーザーズマニュアル

7-5

You need 2 cables to clone 802 RF Terminals; the 

#F38 and the Voice Cloning Cable #T15. The Data Cloning Cable plugs 
into the “Computer” port on each 802 RF Terminal.  This cable must be 
connected to clone properly. 

One jack on the Voice Cloning Cable has two black rings on it – this end 
must plug in to the 

RECEIVING 802 RF Terminal (the one you are 

transmitting to). Plug the single-banded jack end into the 

MASTER 802 RF 

Terminal (the one you are going to record from). 

Once both cables are plugged in to both Terminals, go to the Setup Menu on 
both Terminals. Select 

3 for Voice Operations from the menu. 

The “Receiving” 802 RF Terminal must be started first.  On the receiving 
Terminal, press the 

4 key for Cloning Receiver.  The “Receiving” unit will 

display: 

Now you can start the “Master” 802 RF Terminal by pressing the 

3 key for 

Cloning Master.  The “Master” Terminal will display: 

During the cloning process, you will hear the voice messages played aloud 
as they are copied.  The process takes about 75 seconds to complete. After 
the Terminals are done cloning, they will both display: 

If you did not hear the correct messages or you heard no messages at all, 
check your cables and receiver/master setup - 

from the wrong 802 RF Terminal.   

If you get the DATA XMIT ERROR message, you have to restart the whole 
cloning procedure.