Worth Data 802 RF ユーザーズマニュアル

8-3

 

This is a normal message, generated when the 
Terminal Device first tries to establish contact with a 
Server.  
 

The Terminal is not within range of any Access Point –
regardless of SSID or encryption settings. Move closer 
or hold up to retry. If persistent, do a Site Survey. 
 

Terminal is configured to search for Application Server, 
but it could not find it. 
 

Terminal is configured to get its IP address from a 
DHCP Server. It is broadcasting search. 

Terminal is configured to obtain IP Address from DHCP 
Server, but it could not find a DHCP Server 

The Server has been found. The host program has not 
sent out a prompt yet. If this lasts more than 6 seconds, 
check the host application program for a logic bug. 

This is an indication that the Radio was reset by the 
firmware – normally a rare condition. If you see it more 
than once per week, please call us with information on 
what you were doing at the time it occurred. 

Server Shut Down Due to 
Host Logic Error,  
Press Any Key 
 
 
 
 

Problem is in host program. Notify programmer! 
If the Server detects 5 Sequence Errors in a row, or 5 
messages to a Terminal not Signed In, or 5 Illegal 
Commands, the Server transmits the message to all 
terminals signed in and shuts down. Check your host 
program and correct the logic error before starting up 
again.   

The Server was rebooted. Press any key to be 
transferred to the Mode menu.  

Finish the transaction you have started. The Press F1 
to Sign Out. Then turn off the Terminal and change the 
batteries.  

The terminal will display this message for 20 seconds, 
sign out, and turn off. 
Change the batteries immediately. Don’t let someone 
else pick it up and operate with partially recovered 
batteries 

The Terminal cannot communicate with the radio's PIC 
processor. Cycle power. If message persists, call for 
RMA. 

The terminal's radio is not responding, Call for an RMA.