Worth Data RF Laser ユーザーズマニュアル

 

4 

 
The Base Station can be directly attached to a spare serial port as shown 
below.  This configuration requires the Worth Data F10 5v power supply for 
powering the Base Station. Upon power-up, the Base Station LED will flash 
with 3 more flashes than the channel setting; i.e. if it is set on Channel 0, it 
will flash green three times. If the Channel were set to 7, it would flash green 
10 times. 

 

 
Your software will need to read the serial port as a separate device, unless 
you're using an IBM-compatible computer and Worth Data’s PortKey 
software, which makes serial-port data appear as though it had been typed at 
the keyboard. You can also use the WDR Test Utility to test communication 
with your com port.  

 

If you specified a 25-pin null-modem cable (part number F34) or a 9-pin cable 
(part number F36) when you placed your order, you can cable directly from 
the RF/Reader's Y-Cable port to your computer's serial port. Refer to page 6 
for the details of the pin-outs of the cables.  
 

 

Turn to page 7 to configure the RF Laser Reader using the Setup Menu.