Sony Water Dispenser 2 ユーザーズマニュアル
171
Snapshot Operations in the Menus
Chapt
er
1
4
Sna
p
s
hot
s
5
In the <Attribute> group, press the buttons for the attributes you want to
apply, turning them on.
apply, turning them on.
Carry out the following procedures for each of the attributes.
To apply the cross-point hold attributes
1
Press [XPT Hold], turning it on.
The Snapshot>Attribute>Xpt Hold menu appears. The status area shows a
list of the currently selected regions and bus names.
list of the currently selected regions and bus names.
2
Using either of the following methods, select the register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
• To select all registers, press [All].
3
Press [On].
This enables cross-point hold on the selected bus or buses.
To switch cross-point hold off, press [Off].
To switch cross-point hold off, press [Off].
To apply the effect dissolve attribute
1
Press [Effect Dissolve], turning it on.
2
Turn the knob to set the effect dissolve duration.
To apply the auto transition attribute
Press [Auto Transition], turning it on.
To apply the GPI output attribute
1
Press [GPI Output], turning it on.
Knob Parameter
Adjustment
Setting
values
2
Bus
Bus name selection
–
3
Num
Select number of buses
–
Knob
Parameter
Adjustment
Setting values
2
Duration
Dissolve duration
0 to 999 (frames)