Rowenta Variable steam control iron ユーザーズマニュアル
Before Use
- Please read all of the Instructions for Use and
the Important Safety Guards carefully.
- Remove all packaging from the iron.
- Remove the soleplate protector.
- It is normal for a small amount of smoke and
- Remove the soleplate protector.
- It is normal for a small amount of smoke and
a light odor to be produced the first time it is
used. This will quickly disappear.
used. This will quickly disappear.
- Particles may emit from iron during first use.
They are not harmful and should disappear
after the iron has been used.
after the iron has been used.
Helpful Hints
-
When ironing, start with fabrics that require a low temperature
setting (•) and finish with those which need the highest
temperature (•••).
setting (•) and finish with those which need the highest
temperature (•••).
-
Mixed fiber fabrics should be ironed on the temperature
for the most delicate fabrics. For example a shirt that is
60 % cotton and 40 % polyester should be ironed at the (•)
setting for synthetics.
for the most delicate fabrics. For example a shirt that is
60 % cotton and 40 % polyester should be ironed at the (•)
setting for synthetics.
-
If spray starch is used, spray it onto the reverse side of
the garment. Allow starch to penetrate before ironing
by setting garment aside for 30 seconds.
the garment. Allow starch to penetrate before ironing
by setting garment aside for 30 seconds.
-
For best results, use a mesh type ironing board to allow
excess steam to escape.
excess steam to escape.
-
For delicate fabrics, we recommend carrying out a test on
an unobtrusive area of the garment such as an inner seam.
an unobtrusive area of the garment such as an inner seam.
-
Adhere to manufacturer recommendations on garment label.
3 Way Auto-Off
- If the iron is not moved while it is plugged
in, an internal safety switch will turn it off.
- It will turn off in 8 minutes if left vertically or
in 30 seconds if left on its soleplate or tipped
over. A red flashing light indicates that the
auto-off has been activated.
over. A red flashing light indicates that the
auto-off has been activated.
- To switch the iron on again, move the iron
or gently shake it.
Auto-off is not on/off switch.
Always unplug iron when it is not use.
Always unplug iron when it is not use.
Filling with Water
- Ensure the iron is unplugged.
- Slide the variable steam control completely
- Slide the variable steam control completely
to the left.
- Rest the iron on heel and tilt it forward
approximately 1 inch.
- Fill with water (containing no additives) to
the max mark on the water tank. We recommend
using a the enclosed filling cup rather than filling
under the tap. Iron holds approximately 8.5 oz.
of water.
using a the enclosed filling cup rather than filling
under the tap. Iron holds approximately 8.5 oz.
of water.
- If you need to add water during ironing,
UNPLUG the iron and follow the steps above.
- Ensure iron heats back to temperature
afterwards, that means thermostat light
will go out.
will go out.
NOT DX1700 BIS-1103898563 13/02/06 15:39 Page 3