Raymarine Radar Scanner オーナーマニュアル
22
Pathfinder Radar Scanners
You may need to use longer M8 mounting bolts to secure the scan-
ner if you have used shims to lower the radar beam.
ner if you have used shims to lower the radar beam.
Connecting the radome scanner inter-unit cable
CAUTION:
Before wiring the scanner unit, make sure that the inter-unit
cable is not connected and power is not applied to the display
unit.
Before wiring the scanner unit, make sure that the inter-unit
cable is not connected and power is not applied to the display
unit.
When you have run the inter-unit cable to the scanner location,
connect the cable as follows:
connect the cable as follows:
1. Loosen the 4 (18") or 7 (24") screws securing the scanner cover.
These screws are captive and should remain assembled to the
lower flange assembly. Press the radome inwards to release the
top. This breaks the seal and makes removal easier.
lower flange assembly. Press the radome inwards to release the
top. This breaks the seal and makes removal easier.
2. To avoid losing the scanner cover, tie the cord, attached to the
inside of the base of the scanner, to the eye provided in the cover.
3. If you have a 24" scanner, unscrew and remove the inner cover:
Scanner base
Mounting bracket
or mounting surface
or mounting surface
Greased mounting bolt
D3995-3
Bitumen washer
154_4.book Page 22 Wednesday, October 25, 2000 3:02 PM