Raritan Engineering Command Center CC-SG ユーザーズマニュアル

C

HAPTER 

11:

 

S

YSTEM 

M

AINTENANCE

 153 

 

 

 

Chapter 11: System Maintenance 

Reset CC-SG 

Use the Reset CommandCenter command to reset CC-SG database data – please note that this 
command will not reset system configuration data, such as the IP address of CC-SG. 
1.  On the Setup menu, click Reset CommandCenter.  

 

2.  Type your CC-SG password.  
3.  Either accept the current Broadcast message or edit to create one of your own. 
4.  Type the number of minutes in which to wait until CC-SG is reset in Reset after (min).  

Default is 0, which will reset the CC-SG unit immediately. 

5.  Click OK to reset your CC-SG unit. A success message will appear to confirm the reset. 

Important: Using the Reset command will flush the database of CC-SG. All 
Devices, Ports, and Users will be removed from the CC-SG. Authentication is 
also reset to using Local DB. You should back up the CC-SG before using 
Reset. 

 

Backup CC-SG 

1.  On the Setup menu, click Backup CommandCenter.  
2.  When the Backup CommandCenter screen appears, if desired, check Do not backup logs if 

you do not want the log files backed up. Also check Do not backup firmware binaries if 
you do not want the device firmware binaries to be backed up. Checking these options saves 
time and disk space. 

 

3.  Click OK. The backup file will be saved in the CC-SG file system, and can be restored at a 

later time and a success message will appear to confirm CC-SG backup.