Chaparral K5312/K7313 ユーザーズマニュアル
Configuring the Controller
7-9
Configuring the SCSI Channels
You can change two channel configuration options for each channel:
!
Channel speed—You can change the channel speed for each SCSI channel on
the controller. You can select Ultra or Ultra2. This is helpful if you are
troubleshooting a problem on the channel or if you have legacy ultrawide disk
drives.
the controller. You can select Ultra or Ultra2. This is helpful if you are
troubleshooting a problem on the channel or if you have legacy ultrawide disk
drives.
Note:
Ultra/Ultra2 SCSI is enabled by default. This means that for a single-
ended bus, transfer rates are 40 MB/sec maximum; for an LVD bus, 80
MB/sec maximum. This Ultra SCSI setting only affects the device channel.
Host SCSI channel rates are controlled by setting the host adapter.
MB/sec maximum. This Ultra SCSI setting only affects the device channel.
Host SCSI channel rates are controlled by setting the host adapter.
!
SCSI ID assigned to each channel (initiator ID)—The controller assigns each of
its SCSI channels one of the SCSI IDs (initiator IDs), leaving 15 SCSI IDs
available for devices. You can change the SCSI ID assigned to each channel.
You may need to do this if the default ID, 7, conflicts with a SEP ID. You can
set the ID to any number between 0 and 15.
its SCSI channels one of the SCSI IDs (initiator IDs), leaving 15 SCSI IDs
available for devices. You can change the SCSI ID assigned to each channel.
You may need to do this if the default ID, 7, conflicts with a SEP ID. You can
set the ID to any number between 0 and 15.
To configure the channel:
1
From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu screen displays.
2
Select Channel Configuration and press Enter.
The Channel Configuration screen displays.