Cellboost BOXER 427W ユーザーズマニュアル

6-7-06 - Fifth Proof

Maintenance work can be hazardous if not done in a careful manner. All personnel should 
realize the hazards and strictly follow safe maintenance practices. Failure to comply with these 
safety precautions may result in serious personal injury and/or death. 

•

Use only CPI supplied or approved replacement parts and attachments.Imitation parts may 
lead to unit damage and/or injury to personnel. Warranty may be voided if unauthorized parts 
and attachments are used.

•

Wear the proper protective clothing and personal safety equipment necessary to perform the 
maintenance or service required. 

•

Keep the machine free of grass, leaves, or other debris build-up. 

•

Clean up oil or fuel spillage. 

•

Prior to performing maintenance or service, park the unit in a level area away from 
obstructions and/or work site hazards. 

•

Be sure the area has adequate light and is well ventilated. NEVER operate the machine 
inside a closed area. 

•

Clean-up any oil, grease, mud, water, or snow which might cause the floor surface to become 
slippery.

•

If the machine requires maintenance, take the machine out of service and attach a "Do Not 
Operate" tag at the control panel and remove the ignition key. 

•

If maintenance or repairs require the boom to be raised, the "Hydraulic Cylinder Lock" must 
be installed. 

•

Know where all pinch points and rotating parts on the unit are. These areas must be avoided 
to prevent serious injury. 

•

Remove only those guards or covers on the component being serviced and replace them 
immediately upon completion of the work. 

•

Never attempt to adjust or service engine or machine components while they are hot. 

•

Prior to working on the electrical system: 

•

Disconnect battery cables, removing the battery ground cable first. 

•

When re-connecting the battery, connect the battery ground cables last. 

•

Never allow battery cables to contact hydraulic lines or rub against sharp edges.