ZyXEL Communications Security Camera 3.1 ユーザーズマニュアル
Chapter 1 Command Line Interface
ZyWALL (ZLD) CLI Reference Guide
25
• Enter
range
exactly as it appears, followed by two numbers between 1 and 65535.
1.4.6 Changing the Password
It is highly recommended that you change the password for accessing the ZyWALL. See
for the appropriate commands.
1.5 CLI Modes
You run CLI commands in one of several modes.
See
for more information about the user types. User users can only log in,
look at (but not run) the available commands in User mode, and log out. Limited-Admin users
can look at the configuration in the web configurator and CLI, and they can run basic diagnostics in
the CLI. Admin users can configure the ZyWALL in the web configurator or CLI.
can look at the configuration in the web configurator and CLI, and they can run basic diagnostics in
the CLI. Admin users can configure the ZyWALL in the web configurator or CLI.
At the time of writing, there is not much difference between User and Privilege mode for admin
users. This is reserved for future use.
users. This is reserved for future use.
Table 2
CLI Modes
USER
PRIVILEGE
CONFIGURATION
SUB-COMMAND
What Guest users
can do
can do
Unable to access
Unable to access
Unable to access
Unable to access
What User users
can do
can do
•
Look at (but not
run) available
commands
Unable to access
Unable to access
Unable to access
What Limited-
Admin users can
do
Admin users can
do
•
Look at system
information (like
Status screen)
•
Run basic
diagnostics
•
Look at system
information (like
Status screen)
•
Run basic
diagnostics
Unable to access
Unable to access
What Admin
users can do
users can do
•
Look at system
information (like
Status screen)
•
Run basic
diagnostics
•
Look at system
information (like
Status screen)
•
Run basic
diagnostics
•
Configure simple
features (such as
an address
object)
•
Create or remove
complex parts
(such as an
interface)
•
Configure
complex parts
(such as an
interface) in the
ZyWALL
How you enter it
Log in to the ZyWALL Type enable in User
mode
Type configure
terminal in User or
Privilege mode
terminal in User or
Privilege mode
Type the command
used to create the
specific part in
Configuration
mode
used to create the
specific part in
Configuration
mode
What the prompt
looks like
looks like
Router>
Router#
Router(config)#
(varies by part)
Router(zone)#
Router(config-if-
ge)#
...
How you exit it
Type exit
Type disable
Type exit
Type exit