ZyXEL Communications Security Camera 3.1 ユーザーズマニュアル

Chapter 38 System Remote Management

ZyWALL (ZLD) CLI Reference Guide

You can configure your ZyWALL for remote Telnet access.

The following table describes the commands available for Telnet. You must use the 

configure 

terminal

 command to enter the configuration mode before you can use these commands. 

This command sets a service control rule that allowed the computers with the IP addresses 
matching the specified address object to access the specified zone using Telnet service.

Command Summary: Telnet

[no] ip telnet server

Allows Telnet access to the ZyWALL CLI. The 

no

 command disables Telnet 

access to the ZyWALL CLI.

[no] ip telnet server port <1..65535>

Sets the Telnet service port number. The 

no

 command resets the Telnet 

service port number back to the factory default (23).

ip telnet server rule 

{rule_number|append|insert 

rule_number} access-group 

{ALL|address_object} zone 

{ALL|zone_object} action 

{accept|deny}

Sets a service control rule for Telnet service.

: The name of the IP address (group) object. You may use 1-

31 alphanumeric characters, underscores(

_

), or dashes (-), but the first 

character cannot be a number. This value is case-sensitive. 

: The name of the zone. For the ZyWALL USG 300 and above, 

use up to 31 characters (a-zA-Z0-9_-). The name cannot start with a number. 
This value is case-sensitive.

The ZyWALL USG 200 and lower models use pre-defined zone names like 
DMZ, LAN1, SSL VPN, WLAN, IPSec VPN, OPT, and WAN.

ip telnet server rule move 

rule_number to rule_number

Changes the index number of a service control rule.

no ip telnet server rule rule_number

Deletes a service control rule for Telnet service.

show ip telnet server status

Displays Telnet settings.

Router# configure terminal

Router(config)# ip telnet server rule 11 access-group RD zone LAN action 

-> accept