ZyXEL Communications Security Camera 3.1 ユーザーズマニュアル

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

This example creates a tunnel interface called tunnel0 that uses wan1 as the source, 
168.168.168.168 as the destination, and 10.0.0.100 and 255.255.0.0 as the inner source IP. 

Use these commands to configure settings that apply to the USB storage device connected to the 
ZyWALL. 

Note: For the ZyWALL which supports more than one USB ports, these commands only 

apply to the USB storage device that is first attached to the ZyWALL.

Router> configure terminal

Router(config)# interface tunnel0

Router(config-if-tunnel)# tunnel source wan1

Router(config-if-tunnel)# tunnel destination 168.168.168.168

Router(config-if-tunnel)# ip address 10.0.0.100 255.255.0.0

Router(config-if-tunnel)# exit

Router(config)# show interface tunnel

tunnel interface: 1

  interface name: tunnel0

  local address: ge2

  local address type: bind

  remote address: 168.168.168.168

  mode: gre

  IP address: 10.0.0.100

  netmask: 255.255.0.0

  status: Inactive

  active: no

USB Storage General Commands

show usb-storage

Displays the status of the connected USB storage device.

[no] usb-storage activate

Enables or disables the connected USB storage service.

usb-storage warn number 

<percentage|megabyte>

Sets a number and the unit (percentage or megabyte) to have the ZyWALL send a 
warning message when the remaining USB storage space is less than the set value.

usb-storage mount

Mounts the connected USB storage device.

usb-storage umount

Unmounts the connected USB storage device.

[no] logging usb-storage

Sets to have the ZyWALL log or not log any information about the connected USB 
storage device(s) for the system log.

show logging status usb-storage

Displays the logging settings for the connected USB storage device.

logging usb-storage category 

category level <all|normal>

Configures the logging settings for the specified category for the connected USB 
storage device.

logging usb-storage category 

category disable

Stops logging for the specified category to the connected USB storage device.

logging usb-storage 

flushThreshold <1..100>

Configures the maximum storage space (in percentage) for storing system logs on 
the connected USB storage device.