ZyXEL Communications Security Camera 3.1 ユーザーズマニュアル

Chapter 6 Interfaces

ZyWALL (ZLD) CLI Reference Guide

The following commands show you how to set up a bridge interface named br0 with the following 
parameters: member ge1, IP 1.2.3.4, subnet 255.255.255.0, MTU 598, gateway 2.2.2.2, upstream 
bandwidth 345, downstream bandwidth 123, and description “I am br0”.

The first table below lists the auxiliary 

interface

 commands, and the second table explains the 

values you can input with these commands.

[no] join interface_name

Adds the specified Ethernet interface or VLAN interface to the specified bridge. The no 
command removes the specified interface from the specified bridge.

show bridge available member

Displays the available interfaces that could be added to a bridge.

interface Commands: Bridge Interfaces (continued)

Router# configure terminal

Router(config)# interface br0

Router(config-if-brg)# join ge1

Router(config-if-brg)# ip address 1.2.3.4 255.255.255.0

Router(config-if-brg)# ip gateway 2.2.2.2

Router(config-if-brg)# mtu 598

Router(config-if-brg)# upstream 345

Router(config-if-brg)# downstream 123

Router(config-if-brg)# description I am br0

Router(config-if-brg)# exit

interface Commands: Auxiliary Interface

interface dial aux

interface disconnect aux

Dials or disconnects the auxiliary interface.

interface aux

Enters sub-command mode.

[no] authentication {chap-pap | 

chap | pap | mschap | mschap-v2}

Specifies the authentication type of the auxiliary interface. The 

no

 command 

sets the authentication to chap-pap.

[no] dial-timeout <30..120>

Specifies the number of seconds the auxiliary interface waits for an answer 
each time it tries to connect. The 

no

 command disables the timeout.

[no] dialing-type {tone | 

pulse}

Specifies the dial type of the auxiliary interface. The 

no

 command sets the dial 

type to tone.

[no] idle <0..360>

Specifies the number of seconds the auxiliary interface waits for activity before 
it automatically disconnects. The 

no

 command disables the idle timeout.

[no] initial-string 

Specifies the initial string of the auxiliary interface. The 

no

 command sets the 

initial string to “ATZ”.

: You can use up to 64 characters. Semicolons (;) and 

backslashes (\) are not allowed.

[no] password password

Specifies the password of the auxiliary interface. The 

no

 command clears the 

password.

: You can use up to 63 printable ASCII characters. Spaces are not 

allowed.