Zoom H22 ユーザーズマニュアル

 

Repeatedly press the 

 

4

 

 (MENU) key until

the stereo mode or 4-channel mode top screen
appears again.

 

• When the unit was started on USB power, 

you cannot return to the screen before step 
4.  To return to the top screen, disconnect 
the USB cable to turn power off, and then 
set the [POWER] switch of the H2 to ON to 
start it up normally.

• If you press the 

 

4

 

 (MENU) key instead of 

terminating the connection at the computer, 
the connection will also be interrupted, and 
an error indication will appear at the 
computer. To prevent the possibility of file 
damage, be sure to cancel the connection at 
the computer first.

 

This section describes how to use the H2 as an
audio interface for the computer.

 

The environment requirements for using the
H2 as an audio interface are as follows.

 

■

 

•Windows XP
•Windows Vista
•MacOS X (10.2 or later)

 

■

 

16 bit

 

■

 

44.1 kHz or 48 kHz

 

When the H2 has been recognized as an audio
interface by the computer, the input signal to
the H2 can be recorded directly on the
computer, and the output signal of the
computer is available at the [PHONES/LINE
OUT] jack of the H2.

To perform recording and playback on the
computer, separate dedicated software is

 

A device that allows importing an audio signal into the computer as data, and output of audio data 
from the computer as an audio signal.

 

A function for powering external devices connected to a computer via a USB cable.

H2-E.fm 73 ページ ２００７年７月１１日　水曜日　午後３時１９分