Zenoah EDG2300 ユーザーズマニュアル

12 

• The throttle lock makes starting easier.

Always use it when starting the engine. 

5. While firmly holding the auger as

illustrated, vigorously pull the starter rope. 

6. When engine has ignited first, open the

choke (move the choke lever backward),
pull the starter rope again and the engine
will start. 

7. Pull the throttle lever slightly, and it will be

unlocked automatically. 

8. Allow the engine to warm up for a couple

of minutes before starting operation. 

• When re-starting immediately after

stopping engine, keep the choke open. 

• If the engine won't start even after

repeated attempts, it may be overfed with
fuel. Remove and dry the spark plug, and
try to start again with the choke open. 

■ THROTTLE CABLE ADJUSTMENT 

Check the throttle cable play and adjust to
.04 or .08 in. (1~2mm) at the carburetor
side. 

■ STARTING ENGINE 
1. When first starting up after putting fuel into

the machine, or when re-starting after
running out of fuel, push the priming pump
until fuel runs out the overflow pipe. 

2. Close the choke (push the choke lever

front ward). 

3. While pulling the throttle lever, push in the

throttle lock and set the throttle lever to
the starting position. 

Throttle cable

Adjusting screw

Lock nut

.04 or .08 in.

(1~2mm)

Choke lever

CLOSE

OPEN

Overflow pipe

Priming pump

Throttle lock

Low speed position

High speed position

Starting position