Zhone IMACS-200 ユーザーズマニュアル

ページ / 294
General Features
4-19
IMACS-200 General Features
TCP/IP Network Management
Table 4-8. TCP/IP Screen Actions
Table 4-9. TCP/IP Screen Options and Defaults
HOST TYPE
The Host Type is used to control IP forwarding. When Host Type is set to gateway, IP 
datagrams are allowed being forwarded. When Host Type is set to host, no forwarding is 
allowed. For IP forwarding (routing) to work correctly, a route must be created in the routing 
table. 
DEFAULT IP TYPE
The Default IP Port setting, tells the IMACS 200 where IP packets will be sent when there is 
no matching entry in the routing table. The options are none (no default route used), local 
ethernet 
(SLIP/PPP over DB-9 serial port), wan (wan-1, wan-2, wan-3, wan-4), ipr-fr (IP 
Router via Frame Relay) or SA4 (use of the 4kbps channel available for E1 customers). 
Action
Function
Ping
Test whether the connected device responds to an echo request message. 
After entering the IP address of the host device, the status line will display, 
"Testing . . ." The next message indicates if the host is alive or down.
Netstat
Displays the Network Statistics. See below.
rOute
Shows the Routing screen. See the “Routing” section below.
Save
Saves changes to settings.
Undo
Returns all settings to the last saved state.
Refresh
Used on Testing and Monitoring screens to update statistics, and on other 
screens to redraw the screen.
Main
Returns to the CPU card main screen. If changes are made to settings and 
not saved, you will be prompted to save or lose changes.
Parameter
User Options
Default
HOST IP STATE
actv stdby
stdby
HOST IP ADDR
IP address
0.0.0.0
HOST NETMASK
Network
0.0.0.0
HOST TYPE
host gateway
host
DEFAULT IP TYPE
none          local ether   wan           ipr-fr        
SA4
local ether
DEFAULT IP SLOT
n/a
wan-1 wan-2 wan-3 wan-4) 
n/a
DEFAULT IP TS
n/a   table
n/a
DEFAULT GATEWAY
IP address
0.0.0.0
RPT1 IP ADDR
IP address
0.0.0.0
RPT1 COMMUN STR
blank
RPT2 IP ADDR
IP address
0.0.0.0
RPT2 COMMUN STR
blank
RPT3 IP ADDR
IP address
0.0.0.0
RPT3 COMMUN STR
blank