Zhone IMACS-200 ユーザーズマニュアル
General Features
4-23
IMACS-200 General Features
Remote Administration
b. Choosing Host type as gateway will set up the downstream management channel, or
SCC4. The IP static route must be set via the rOute option after you have saved the
above. To set up a static route, choose the rOute option from the tcp/Ip screen and
choose the add option, stepping through the required fields as shown in Figure 4-14.
This route will setup the SCC4 connection for the forwarded IP packets. The IP net
and SubNetMask indicate which packets will be forwarded.
above. To set up a static route, choose the rOute option from the tcp/Ip screen and
choose the add option, stepping through the required fields as shown in Figure 4-14.
This route will setup the SCC4 connection for the forwarded IP packets. The IP net
and SubNetMask indicate which packets will be forwarded.
Figure 4-14.Setting up a Static IP Route on the IMACS-200
7. Enter in the DEFAULT GATEWAY:[IP address]
8. Save the specified settings.
a. If using remote connectivity via WAN from an IMACS 800 or IMACS 200 acting as
a gateway, enter the IP route (option O).
b. If using remote connectivity from an IMACS MCC card, before pinging any of the
daisy-chained nodes you must inform your IP network of the route via the route
command. For example (using Figure 4-12 on page 4-22 as the network diagram), you
will need to add the following routes to your IP host:
command. For example (using Figure 4-12 on page 4-22 as the network diagram), you
will need to add the following routes to your IP host:
route add 10.1.2.2 10.1.1.2
route add 10.1.2.3 10.1.1.2
route add 10.1.2.4 10.1.1.2
route add 10.1.2.5 10.1.1.2
9. Go back up to the HOST I P STATE in step 2 and change it to actv
10. Save the specified settings.
11. From a PC on the same IP network, enter:
a. Ping [device IP address]