Zhone IMACS-200 ユーザーズマニュアル
B-8
Error Messages
Model No.
Running Head
Redundancy switchover is complete.
You have asked the system to switch to the redundant WAN port, and the switchover was
successfully completed. (This is not an error message; it normally appears after you initiate
the switchover.)
successfully completed. (This is not an error message; it normally appears after you initiate
the switchover.)
Redundant WAN is taken already.
You cannot switch to the redundant WAN port in slot WAN-4 if it is already in use from a
previous WAN port switch.
previous WAN port switch.
Remote session active. Can’t change setting.
You cannot change this setting because a remote operator has accessed the system and is
controlling it. Wait for that operator to log off and disconnect.
controlling it. Wait for that operator to log off and disconnect.
Restricted field.
You cannot access the Superuser password field on the CPU port Main Screen. This password
is factory-assigned.
is factory-assigned.
Selected circuit is under the test already.
The current circuit is already being tested.
Simultaneous loopback tests not allowed.
You cannot activate two or more loopbacks at the same time.
SNMP Options not available on this CPU.
The current CPU port does not support SNMP configuration.
SR TS overlapping.
The subrate circuit assigned does not allow enough space for a previously assigned circuit on
the same subrate time slot. For example, if you have a 19.2 kbps device on subrate time slot 1
in b-5 framing, you cannot assign another 19.2 kbps circuit to subrate time slot 2, because the
circuit on 1 actually occupies subrate time slots 1 and 2. You must therefore assign that other
circuit to subrate time slot 3 or 4.
the same subrate time slot. For example, if you have a 19.2 kbps device on subrate time slot 1
in b-5 framing, you cannot assign another 19.2 kbps circuit to subrate time slot 2, because the
circuit on 1 actually occupies subrate time slots 1 and 2. You must therefore assign that other
circuit to subrate time slot 3 or 4.