VistaQuest N7227V5 ユーザーズマニュアル
– 13 –
Installing
the Control and RF Receiver Circuit Boards Together in the Cabinet
1.
Hang two
short (black) mount ing clips (provided with receiver) on the
raised cabinet tabs, as shown in Detail B in Figure 3.
2.
Insert the top of the receiver board (removed from its own case as de -
scribed in
scribed in
its in struc tions) into the slots at the top of the cabinet, as shown
in Detail A in Figure 3. Make sure that the board rests on the correct row of
tabs, as shown.
tabs, as shown.
3.
Swing the base of the board into the mounting clips and secure it to the
cabinet with the ac com panying screws (see Detail B in Fig. 3).
cabinet with the ac com panying screws (see Detail B in Fig. 3).
4.
Insert the top of the control's board into the slot in the clips and position
two
two
long (red) clips at the lower edge of the board (see Detail C).
5.
Swing this board into place and secure it with two additional screws.
6.
Insert grounding lugs (supplied with the re ceiver) through the top of the
cabinet into the
cabinet into the
left-hand terminals of the antenna blocks (at the upper
edge of the receiver board) and se cure them to the cabinet top with the
screws provided, as shown in Detail D.
screws provided, as shown in Detail D.
7.
Insert the receiver's antennas through the top of the cabinet, into the
blocks'
blocks'
right-hand terminals, and tighten the screws.
8.
Setup and wiring of the receiver. is contained in the WIRELESS (RF)
ZONE EXPANSION (5700 & 5800 RF SYSTEMS) section.
ZONE EXPANSION (5700 & 5800 RF SYSTEMS) section.
Standard Phone Line Connections
The wiring connections shown here are not applicable if the 4285 Phone
module is used. Refer to the 4285 Phone module section for information
regarding phone line connections, which are different than those shown here.
module is used. Refer to the 4285 Phone module section for information
regarding phone line connections, which are different than those shown here.
Incoming phone line and handset wiring is connected to the main terminal
block (via a RJ31X jack ) as indicated below and shown in Figure 4.
block (via a RJ31X jack ) as indicated below and shown in Figure 4.
Term. 17:
Local Handset (TIP – Brown*).
Term. 18:
Local Handset (RING – Gray*).
Term. 19:
Incoming Phone Line (TIP – Green*).
Term. 20:
Incoming Phone Line (RING – Red*).
*
Colors of wires in Direct Connect Cord.
TERMINALS
ON CONTROL
ON CONTROL
EARTH GROUND
➡
PREMISES
PHONES
PHONES
Handset
Incoming
Telco Line
TIP
RING
BROWN (TIP)
GRA
Y
(RING)
GREEN (TIP)
RED (RING)
RJ31X
JACK
PLUG
DIRECT
CONNECT
CORD
➧
TIP
RING
GROUND
▲
▲
▲
INCOMING TELCO LINE
▲
{
{
17 18 19 20 21
Figure 4. Standard Telephone Line Connections