VistaQuest N7227V5 ユーザーズマニュアル

– 39 –

Section 6. RELAY OUTPUT DEVICES

Relay Device Basics

Relays are programmable switches that can be used to perform many different
functions. They can be used to turn lights on and off, control sounders, or for
status indications. In this system, each relay must be programmed as to how
to act (ACTION), when to activate (START), and when to deactivate (STOP).
Each of these is described below, and in the programming procedure for

✱

and

✱

81 interactive modes that are provided at the end of this section.

The control supports a total of 4 output relays.

The 4204 Relay modules provide Form C (normally open and normally
closed) contacts.

✱

80 and

✱

81 interactive modes, a series of keypad prompts will request

entries for programming of the Relay outputs used in the system. Refer also to
“OUTPUT RELAY DEVICE WORKSHEET FOR

✱

80 AND

✱

81 INTERACTIVE

MODES” in the blank programming form provided in the separate
Programming Guide manual.

4204 Relay Modules

4204 Setup

1 2 3 4 5

OFF ON

@@@@@@@@e?

@@h?

@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e

@@@@@@@@

?@@

?@@@@@@@@

?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@e?@@@@@@@@?e@@@@@@@@

@@g

@@@@@@@@

The 4204 unit can be mounted either remotely or in the control panel. The
following steps should be taken to properly set up the 4204:

1. Connect the 4204 to the control's remote keypad terminals (4–7), using

the con nector supplied with the 4204. Use standard 4-conductor twisted
cable for long wiring runs.

2. Set the 4204's DIP switch for a device address of "1" (switch 2 "OFF"

and switches 3, 4, and 5 "ON"). Switch 1 determines the unit's cover
tamper response ("ON" = disabled, "OFF" = enabled).

3. Connect the desired field wiring to the unit's relay contact terminals. See

Figure 9.

Supervision

4204 modules are supervised against removal. CHECK and zone 09 will be
displayed if a module is disconnected from the control’s keypad terminals (4,
5, 6, & 7).

DIP SWITCH
FOR SETTING DEVICE ADDRESS
AND ENABLING/DISABLING TAMPER

COVER TAMPER (REED) SWITCH

TB1

4204

TB2

4-PIN CONSOLE PLUG

12
11
10

9
8
7
6
5
4
3
2
1

RELAY

RELAY 4

TYPICAL

(SHOWN "OFF")

EITHER OR BOTH
CAN BE USED

DATA IN
FROM CONTROL

(–) GROUND

DATA OUT
TO CONTROL

(+) 12V

YEL

BLK

GRN

RED

4204

Figure 9. 4204 Connections to Control

Programming Options Defined

The following will help you understand the programming of OUTPUT RELAYS
when using

✱

80 and

✱

81 modes. The options used to start and stop these

relays are described below, followed by the actual screen prompts and
available entries.