Viper 5706V オーナーマニュアル

Button Auto Lock

When On, the remote control buttons lock if more than 20 seconds
lapses between button presses. If a button is pressed when locked, a
fault tone is emitted. To unlock the buttons; press the

button followed

by the

button, the buttons unlock and tones play to conﬁrm.

Car Select

Car 2

must ﬁrst be turned On (See Remote Features menu under “Pro-

gramming” on page 44 to turn on). Press and hold the

button

for 3 seconds. The remote ﬂashes the LED and beeps once or twice to
indicate the selected Car is 1 or 2, release the button for Car Select
or continue to hold for programming.

Release the

button, then press and release while the LED and

beeps continue to perform Car Select. Once the car is selected a com-
mand can be performed by pressing one of the command buttons.

Programming

To enter: Press and hold the

button for eight seconds, the remote

emits one long beep and turns the LED on, the programming main
menu has been accessed (see menu listings below).
To exit: Press and release the

button once, then press and hold the

button again. One short and one long beep is emitted for each

step back, the LED turns off when programming is exited.

1. Sensor Adjust
To avoid unintended alarm triggers, it is recommenced that an
authorized Directed dealer perform all sensor adjustments.

2. Remote Features menu
After entering the programming mode: Press and hold the
button, two LED ﬂashes and beeps indicate the remote features