Verdero Water Pump VF5 ユーザーズマニュアル
12
2.7 Assembly, Installation and Commissioning
• A qualified electrician should be consulted on operations where there may be risk of electrical
hazard
• Always isolate the power supply before working on the pump
• Check compatibility of the hose material with the product being pumped
• Check compatibility of the lubricant with the product being pumped
• Do not over grease the front cover O-ring. If the grease contaminates the VERDERLUBE,
• Check compatibility of the hose material with the product being pumped
• Check compatibility of the lubricant with the product being pumped
• Do not over grease the front cover O-ring. If the grease contaminates the VERDERLUBE,
the performance of the hose may be affected
• At all times the pump must be between one third and one half full with VERDERLUBE
lubricant
• Check all nuts and bolts are tightened to the required torque settings in `Parts List`
YOU ARE ADVISED TO FOLLOW AND COMPLY WITH THE SAFETY INSTRUCTIONS FROM
VERDER FULLY – IF YOU DO NOT, YOU RUN THE RISK OF SERIOUS OR FATAL INJURY
TO THE OPERATOR. IF YOU DO NOT UNDERSTAND ANY ITEMS, THEN YOU SHOULD
NOT PROCEED UNTIL YOU HAVE CLARIFIED THE POINTS WITH YOUR DISTRIBUTOR.
VERDER FULLY – IF YOU DO NOT, YOU RUN THE RISK OF SERIOUS OR FATAL INJURY
TO THE OPERATOR. IF YOU DO NOT UNDERSTAND ANY ITEMS, THEN YOU SHOULD
NOT PROCEED UNTIL YOU HAVE CLARIFIED THE POINTS WITH YOUR DISTRIBUTOR.