Vermont Castings FK28/2960 ユーザーズマニュアル

3

1.  Attach the snapstat assembly to the snapstat bracket 

with two sheet metal screws. (Fig. 8) Remove the 
1/4-20 x 3/8” hex head bolt installed in the hole in the 
right rear ledge of the firebox. Use that bolt to secure 
the snapstat bracket to the firebox. The mounting 
hole is slotted to allow you to adjust the bracket so 
that the snapstat bracket head makes contact with 
the firebox. (Fig. 9)

2.  Attach the fan to the rear shroud by engaging the 

upper flange of the fan skirt under the lower edge of 
the shroud and se cure the skirt with the four screws 
and one star washer provided. (Fig. 9,10)

3.  The rheostat control switch attaches to the left side 

of the valve bracket at the front of the stove. (Fig. 11)
•  Remove the plug from the rheostat bracket. 
•  Insert the switch box shaft through the hole in 

the back of the right side of the valve bracket, 
aligning the locator pin with the smaller hole in 
that bracket. 

•  Attach the retaining nut to the switch control shaft 

to secure it to the plate.

•  Attach the control knob to the rheostat shaft.
•  Use the wire tie to secure the fan and rheostat 

wire harnesses together.

ST239
FDV attach snapstat
12/13/99   djt

1/4-20 x 3/8” 

Phillips Screw

1/2” 

Sheet 

Metal 

Screw

Snapstat

Snapstat Bracket

ST239

Fig. 8  Snapstat assembly and installation.

ST240
FDV attach fan
12/13/99   djt

Upper 

Flange

To 

Control 

Valve

ST240

Fig. 9  The upper flange of the fan skirt should be located 
behind the lower edge of the shroud.

ST240
FDV attach fan
12/13/99   djt

ST241

Fig. 10  Correct position of fan skirt installation.

ST347a
JUV
FK28 
rheostat install
9/21/00

Retaining Nut

Control Knob

ST347a

Fig. 11  Attach rheostat.

Rheostat