Vanguard Heating UNVENTED (VENT-FREE) NATURAL GAS LOG HEATER ユーザーズマニュアル
3
105273
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
IDENTIFICATION
Figure 1 - Product Identification
Flame-Max
®
Golden Oak Logs
PRODUCT
FEATURES
FEATURES
OPERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANS Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free
heaters. This heater may also be operated as
a vented decorative product (ANS Z21.60)
by opening flue damper (non-thermostat
operation only).
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and ap-
proved to ANS Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free
heaters. This heater may also be operated as
a vented decorative product (ANS Z21.60)
by opening flue damper (non-thermostat
operation only).
SAFETY PILOT
This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
requires no matches, batteries, or other
sources to light heater.
UNPACKING
CAUTION: Do not remove the
metal Data Plates from the grate
assembly. The Data Plates contain
important product information.
assembly. The Data Plates contain
important product information.
1.
Remove logs and heater base assem-
bly from carton.
bly from carton.
Note:
Do not pick up
heater base assembly by the burner.
This could damage heater. Always
handle base assembly by grate.
This could damage heater. Always
handle base assembly by grate.
2.
Remove all protective packaging ap-
plied to logs and heater for shipment.
plied to logs and heater for shipment.
3.
Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
age. If damaged, promptly inform
dealer where you bought heater.
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1, also known as NFPA 54*.
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note:
Where listed vented decorative logs
are required, thermostat operation is not
permitted.
permitted.
AUT
O
MAN
OFF
ST
ATUS
ON
LO
HI
TEMP
Control Knob
Piezo
Ignitor
Ignitor
One Piece
Log Set
Log Set
Base Assembly
Optional
Remote
Control
Remote
Control
Flame
Adjustment
Knob
Adjustment
Knob
Optional
Selector
Switch
Selector
Switch
REMOTE CONTROL
ACCESSORIES
ACCESSORIES
There are four optional remote controls that
can be purchased separately for this log
heater:
can be purchased separately for this log
heater:
• wall switch
• wall thermostat
• hand held ON/OFF remote
• hand held thermostat remote
See Accessories, page 25.
The wall thermostat or hand-held thermo-
stat may not be used where vented decora-
tive listing is required.
stat may not be used where vented decora-
tive listing is required.