Univex 5.4 ユーザーズマニュアル

While doing 
remote 
control 
procedure, 
the remote 
control stops 
working.

• If you don’t 

press 
a button for 20 
seconds in a 
programming 
sequence, the 
remote shuts off 
its programming 
function.

Start over again.

When you 
press a button 
on the remote 
control, the 
equipment 
doesn’t do 
what you 
expect.

• Maybe you 

didn’t set the 
remote to the 
mode for the 
equipment you 
want to control.

• Maybe you’re 

not pointing the 
remote control 
right at the TV 
(or other 
equipment).

• Maybe the 

remote control is 
missing 
batteries, maybe 
you put the 
batteries in the 
remote the 
wrong way, or 
maybe the 
batteries are 
weak or dead.

• Maybe you 

didn’t set up the 
remote to 
control the 
equipment.

• Press the correct mode button to 

set the remote to the mode for the 
equipment you want to control.

• The remote control uses IR signals 

to control all equipment except for 
the receiver (when using UHF). IR 
signals travel only 40 feet or less, 
and can’t go through walls or other 
solid objects. You must point the 
remote control right at the 
equipment, with no objects to 
block the signal path.

• If the batteries are missing or dead, 

put fresh AAA-size batteries in. If 
the remote has fresh batteries, 
check whether you put them in the 
right way. If you didn’t, take them 
out and put them in the right way.

• Make sure you set up the remote 

to control all the equipment you 
want to use. See Program the 
Remote to Control Your TV on 
page S-2 and Programming for 
Other Equipment on page 2.