Univex 1856 ユーザーズマニュアル

Answering system operation

Day & time announcements

Before playing each message, the answering sys-
tem announces the day and time the message 
was received. 

Before using the answering system, follow the 
steps on the left to set the day and time, so 
messages are dated correctly. If the clock is not 
set, before playing messages, the system will 
announce "power failure" each time.

To begin, press and hold the CLOCK RESET but-
ton for two seconds.

The system uses voice prompts to guide you. Each 
time you press 

SKIP or 

REPEAT , the day, hour, 

minute or year increases or decreases by one. 
When you hear the correct setting, press CLOCK 
RESET to move to the next setting.

You can press CLOCK RESET at any time to listen 
to the current day and time without changing it.

Press CLOCK RESET,

the system will announce 
the current setting.

Press and hold

CLOCK RESET, the system 
will announce the current 
day setting, then announces 
"To change, press 

REPEAT, to change the 
hour, press 

CLOCK RESET."

 Press  SKIP

or

REPEAT until the 

system announces the 
correct day, then press 
CLOCK RESET.

Press  SKIP or

REPEAT until the system 

announces the correct hour, 
then press CLOCK RESET.

Press  SKIP or 

REPEAT until the sys-

tem announces the correct 
minutes, then press 
CLOCK RESET.

Press  SKIP or 

REPEAT until the 

system announces the 
correct year, then press 
CLOCK RESET. The system 
announces the current 
clock setting.

1. The answering system must be on to review or 

change settings.

2. Caller ID provides the time and date. Set the 

year so that the day of the week can be calcu-
lated from the caller ID information. After you 
set the time once, it will always be set auto-
matically with incoming caller ID information. 
The time will be set automatically only if you 
subscribe to caller ID service provided by your 
local telephone company (page 15).

21