Ultratec PFI-9D ユーザーズマニュアル

Operating Procedure

1.  The fog machine must be connected to a grounded supply of at least 15 amps free of any interference.
2.  Open a 20 Litre (5 Gallon) container of Ultratec Special Effects fog fluid and insert the fluid pickup tube into the 

spout of the fluid container.

3.  Connect the Remote Handset into the rear panel connector located on the rear panel. (When using DMX the 

Remote is not required).

4.  Activate the Power switch located on the rear panel. The Power switch and Handset indicator will illuminate to 

indicate the presence of power. If the Handset indicator does not illuminate, ensure the connector is properly 
inserted.

5.  The Handset indicator will begin to flash slowly, but will speed up 

when the fog machine is ready to operate. After approximately 9 
minutes, the fog machine will be fully heated and is ready for full 
output; the indicator will be on solid.

6.  It may be necessary to prime fluid into the system to expel any 

air. The Variflow control on the remote handset should be set to 
the full position. A dry hose can take between 45-60 seconds to 
prime. This only needs to be done if the unit was left to run dry.

7.  To adjust the depth of the hose, simply loosen Nut ‘A’ and slide 

up or down the hose and retighten. Be careful not to pinch off 
the flow of fluid.

NOTE: In order to prime the fog machine, the Handset Indicator must be a solid red.

A) Mount the Regulator Bracket to a wall or other secure 
location.
B) Attach the female coupler to the male coupler of the 
Power Fog Industrial w/ Air Option or Power Fog Industrial 
9D w/ Air Option.
C) Attach the air hose to the male coupler of the mounted 
regulator.
D) Adjust for the desired air pressure (typically 25-50 psi).