X10 Wireless Technology AIRSIGHT XX34A ユーザーズマニュアル
56
4.1.13 There’s no picture (Problems with ActiveX Controller)
If using IE browser to connect the camera for the first time, and there is no image displayed, you might need to
install ActiveX. You need to change some browser settings to enable ActiveX. (See: For IE Browser).
install ActiveX. You need to change some browser settings to enable ActiveX. (See: For IE Browser).
4.1.14 Problems with network bandwidth
The image frame rate is subject to the following factors:
1. Network bandwidth.
2. PC performance, network environment and display preference setting (brightness, theme, etc).
3. The number of visitors (too many visitors will slow down the image frame rate).
4. Choice of switch or hub (use a switch for multiple IP Camera Servers rather than a HUB).
1. Network bandwidth.
2. PC performance, network environment and display preference setting (brightness, theme, etc).
3. The number of visitors (too many visitors will slow down the image frame rate).
4. Choice of switch or hub (use a switch for multiple IP Camera Servers rather than a HUB).
4.1.15 How to register an account from DDNS web
You can enter http://www.dyndns.com and register an account.
4.1.16 Pop-up the prompt” Fail to connect to the device…”
?
This prompt only appears in the case of using multiple cameras.
When you set multiple cameras, and the device status light changes to yellow
please make sure the
cameras are connected to power and working correctly.
4.2 Default Parameters
Default network Parameters
IP address: dynamic
Subnet mask: dynamic
Gateway: dynamic
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: None, i.e., leave blank.
IP address: dynamic
Subnet mask: dynamic
Gateway: dynamic
DHCP: Disabled
DDNS: factory DDNS and third party DDNS
Username and password
Default administrator username: admin
Default administrator password: None, i.e., leave blank.