Sony NEX-VG20H ユーザーズマニュアル
1
Table of C
on
ten
ts
Sear
ch image
ch image
Inde
x
x
US
4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
jack of your camcorder.
Charging time
Approximate time (min.) required when you fully charge a fully discharged battery pack.
Battery pack
Charging time
NP-FV70 (supplied)
195
NP-FV100
390
The charging times shown in the table above are measured when charging the camcorder at a
temperature of 25
C (77 °F). It is recommended that you charge the battery in a temperature range of
10
C to 30
C (50 °F to 86 °F).
Tips
See page 97 on recording and playing time.
When your camcorder is on, you can check the approximate amount of remaining battery power with the
remaining battery indicator at the upper right on the LCD screen.
To remove the battery pack
Slide the POWER switch to OFF. Slide the BATT (battery) release lever () and remove the
battery pack ().
To use a wall outlet (wall socket) as a power source
Make the same connections as “Step 3: Charging the battery pack” (p. 15). Even if the battery
pack is attached, the battery pack is not discharged.
Charging the battery pack abroad
You can charge the battery pack in any countries/regions using the AC Adaptor supplied with
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
your camcorder within the AC 100 V - 240 V, 50 Hz/60 Hz range.
Notes
Do not use an electronic voltage transformer.
BATT (battery) release lever