Sony VGC-RBXX プリント

 

 

2/2

 

 

 

 

 

 

 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Step 6. Remove the indicated screws from 
the opposite side of the bracket and set 
aside. 

Step 7. Pull out the original hard drive from 
the bracket in the direction of the arrow. 

IMPORTANT! Take note of the original 
position of the drive inside the bracket. 

Step 8. Gently insert the new hard drive into 
the bracket in the direction of the arrow. Align 
the new drive in the same position as the 
original hard drive. 

Step 10. Slide the hard drive bracket 
enclosures back inside the unit, making sure 
all holes are lined up. 

 

Step 12. Gently reconnect the previously 
removed power connector marked P8 [

into the hard drive as indicated above.  

 

Gently reconnect the serial ATA 

cable [

] into the hard drive as indicated 

above. 

Step 14. Re-assemble the chassis panel 
cover. And reinstall the screws removed in 
step 1. Connect your PC and continue with 
the recovery following the instructions on the 
back of the recovery disk’s case. Return the 
original hard drive to Sony following the 
included shipping instructions. 

Step 11. Using the enclosed magnetic 
screwdriver, reinstall the two (2) previously 
removed screws . 

IMPORTANT! Do not over 

tighten the screws. 

 

Step 9. Reinstall the four (4) previously 
removed screws  into indicated positions on 
both sides of the bracket. 

IMPORTANT! 

Do not over tighten the screws!

 

 

 

Notice position of the 

bracket and HDD 

Notice position                

of the pins