SMC Networks TIGERSWITCH SMC6752AL2 ユーザーズマニュアル

4-38

This command specifies the client IP addresses that are allowed 
management access to the switch through various protocols. Use the no 
form to restore the default setting.

[no] management {all-client | http-client | snmp-client | 

telnet-client} start-address [end-address]

• all-client - Adds IP address(es) to the SNMP, web and Telnet 

groups.

• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.

All addresses

Global Configuration

• If anyone tries to access a management interface on the switch from 

an invalid address, the switch will reject the connection, enter an event 
message in the system log, and send a trap message to the trap 
manager.

• IP address can be configured for SNMP, web and Telnet access 

respectively. Each of these groups can include up to five different sets 
of addresses, either individual addresses or address ranges. 

• When entering addresses for the same group (i.e., SNMP, web or 

Telnet), the switch will not accept overlapping address ranges. When 
entering addresses for different groups, the switch will accept 
overlapping address ranges.

• You cannot delete an individual address from a specified range. You 

must delete the entire range, and reenter the addresses.