SMC Networks TIGERSWITCH SMC6752AL2 ユーザーズマニュアル

4-202

Example 
The following example shows how to set the interface configuration mode 
to VLAN 1, and then assign an IP address to the VLAN:

This command configures the VLAN membership mode for a port. Use 
the no form to restore the default.

switchport mode {trunk | hybrid | private-vlan}
no switchport mode

• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk 

is a direct link between two switches, so the port transmits tagged 
frames that identify the source VLAN. Note that frames belonging 
to the port’s default VLAN (i.e., associated with the PVID) are also 
transmitted as tagged frames.

• hybrid - Specifies a hybrid VLAN interface. The port may transmit 

tagged or untagged frames.

• private-vlan - For an explanation of this command see “switchport 

mode private-vlan” on page 4-213. 

All ports are in hybrid mode with the PVID set to VLAN 1.

Interface Configuration (Ethernet, Port Channel)

Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#