SMC Networks TIGERSWITCH SMC6752AL2 ユーザーズマニュアル

2-9

6. Then save your configuration changes by typing “copy running-config 

startup-config.” Enter the startup file name and press <Enter>.

The switch can be configured to accept management commands from 
Simple Network Management Protocol (SNMP) applications such as 
SMC EliteView. You can configure the switch to (1) respond to SNMP 
requests or (2) generate SNMP traps.

When SNMP management stations send requests to the switch (either to 
return information or to set a parameter), the switch provides the 
requested data or sets the specified parameter. The switch can also be 
configured to send information to SNMP managers (without being 
requested by the managers) through trap messages, which inform the 
manager that certain events have occurred.

Community strings are used to control management access to SNMP 
stations, as well as to authorize SNMP stations to receive trap messages 
from the switch. You therefore need to assign community strings to 
specified users or user groups, and set the access level. 

Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart 
Console#show ip interface
 IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
 and address mode: User specified.
Console#copy running-config startup-config
Startup configuration file name []: startup
\Write to FLASH Programming.

\Write to FLASH finish.
Success.