SmartBridges sB3010 ユーザーズマニュアル

 

 

 

Page 58 of 80 

 

i n t e l l i g e n t     w i r e l e s s     p l a t f o r m

 

airHaul™ Nexus User Guide

 

 
The user can edit the SNMP Community String and SNMP Access filters. The SNMP community 
needs to match with the SNMP monitoring software used. The SNMP Access Filters allows you to 
determine which host(s) is authorized to monitor the device using SNMP. It is recommended that you 
set this for security reason and prevent an attack. To change the SNMP security settings, click on the 
SNMP security link in the System Configuration page.  Figure 6-2 shows the SNMP Security 
Configuration page. 
 
Follow the steps below to change the SNMP security settings. 

 

1.  Enter New Community and Confirm Community with the same string. 
 
2. Check 

the 

‘SNMP Access Filters’ Enable box. 

 
3.  Enter Access Filters IP Address and Mask up to three IP’s settings can be entered. 
 
4. Click 

the 

 button. 

 

Display SNMP Community String that is currently used to communicate to 
the device through SNMP  

User can change the SNMP Community String by entering a new 
Community string 

User must enter the same community string as New Community string to 
confirm. 

Display the Current Access Filter status 
User can change the Access Filter status. 

List of 3 IP filters. 
User can enter the IP address and mask. Only the specified host can 
have SNMP access to the airHaul.