Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル
AT Command Set
MC35_ATC_01_V04.00
Page 112 of 238
02.04.2002
4.39 AT+CR Service reporting control
Test command
AT+CR=?
Response
+CR: (list of supported
<mode>s) OK
Parameter
See write command
Read command
AT+CR?
Response
+CR: <mode> OK
Parameter
See write command
Write command
AT+CR=<mode>
Response
Configures the TA whether or not to transmit an intermediate result code +CR:
<serv> to TE when a call is being set up.
OK
<serv> to TE when a call is being set up.
OK
Parameter
<mode> 0 disable
1 enable
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during con-
nect negotiation when the TA has determined the speed and quality of service
to be used, before any error control or data compression reports are transmit-
ted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv
nect negotiation when the TA has determined the speed and quality of service
to be used, before any error control or data compression reports are transmit-
ted, and before any final result code (e.g. CONNECT) appears.
+CR:<serv
>
Parameter
<serv>
REL ASYNC
asynchronous non-transparent
Reference
GSM 07.07
Note
The PLMN influences the second air interface (to the terminator), therefore an-
other mode may be established from the network
other mode may be established from the network