Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル
AT Command Set
MC35_ATC_01_V04.00
Page 151 of 238
02.04.2002
6.1.3 AT+CGDATA Enter data state
Test command
AT+CGDATA=?
The test command is used for requesting information on the supported layer 2
protocols to be used between the TE and MT.
protocols to be used between the TE and MT.
Response
+
CGDATA: (list of supported <L2P>s)
OK/ERROR/+CME ERROR
Parameter
<L2P>
See write command
Write command
+CGDATA=[<L2P>,
[<cid>[,<cid>,…]]]]
[<cid>[,<cid>,…]]]]
The execution command causes the MT to perform whatever actions are nec-
essary to establish communication between the TE and the network using one
or more GPRS PDP types. This may include performing a GPRS attach and
one or more PDP context activations. Commands following +CGDATA com-
mand in the AT command line shall not be processed by the MT.
essary to establish communication between the TE and the network using one
or more GPRS PDP types. This may include performing a GPRS attach and
one or more PDP context activations. Commands following +CGDATA com-
mand in the AT command line shall not be processed by the MT.
Parameter
<L2P>
layer 2 protocol to be used between the TE and MT
PPP or 1 for layer2 protocol PPP
PPP or 1 for layer2 protocol PPP
<cid>
PDP Context Identifier is a numeric parameter which
specifies a particular PDP context definition. The pa-
rameter is local to the TE-MT interface and is used in
PDP context-related commands. If no context is specified,
an internal context 0 with default QoS (network sub-
scribed) and APN from EEPROM (if there is one) is used.
1
2
specifies a particular PDP context definition. The pa-
rameter is local to the TE-MT interface and is used in
PDP context-related commands. If no context is specified,
an internal context 0 with default QoS (network sub-
scribed) and APN from EEPROM (if there is one) is used.
1
2
Response
If successful, the MT issues the intermediate result code CONNECT and en-
ters V.25ter online data state:
CONNECT
ters V.25ter online data state:
CONNECT
After data transfer is complete, and the layer 2 protocol termination procedure
has completed successfully, the command state is re-entered and the MT re-
turns the final result code
OK
has completed successfully, the command state is re-entered and the MT re-
turns the final result code
OK
If the <L2P> parameter value is unacceptable to the MT, the MT returns an
ERROR or +CME ERROR response:
ERROR/+CME ERROR
ERROR or +CME ERROR response:
ERROR/+CME ERROR
In the event of erroneous termination or a failure to start up, the command
state is re-entered and the MT returns
NO CARRIER
or, if enabled,
+CME ERROR
state is re-entered and the MT returns
NO CARRIER
or, if enabled,
+CME ERROR