Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル
AT Command Set
MC35_ATC_01_V04.00
Page 172 of 238
02.04.2002
7.2 ^SSTN Remote-SAT Notification
Proactive
Commands
Commands
Every time the SIM application issues a proactive command, via the ME, the TA
will receive a notification. This indicates the type of proactive command issued.
AT^SSTGI must then be used by the TA to request the parameters of the proac-
tive command from the ME.
Upon receiving the ^SSTGI response from the ME, the TA must send AT^SSTR
to confirm the execution of the proactive command and provide any required user
response, e.g. selected menu item.
will receive a notification. This indicates the type of proactive command issued.
AT^SSTGI must then be used by the TA to request the parameters of the proac-
tive command from the ME.
Upon receiving the ^SSTGI response from the ME, the TA must send AT^SSTR
to confirm the execution of the proactive command and provide any required user
response, e.g. selected menu item.
Unsolicited result code
^SSTN: <cmdType>
Parameters
<cmdType>
Proactive command ID
Terminate
Proactive
Command
Proactive
Command
When the SIM application has issued a proactive command, via the ME, to the
TA, it is possible that this command must be terminated. The ^SSTN Unsolicited
Result Code is sent but with a different command type to indicate the termination
of the specified command.
TA, it is possible that this command must be terminated. The ^SSTN Unsolicited
Result Code is sent but with a different command type to indicate the termination
of the specified command.
Unsolicited result code
^SSTN: <cmdTerminateValue>
Parameters
<cmdTerminateValue>
Terminate proactive command ID
SIM Applica-
tion returns to
main menu
tion returns to
main menu
Notification to the TA when the SIM Application has finished a command cycle
and again enters its main menue.
This URC should be used to open this menue on the sreen.
and again enters its main menue.
This URC should be used to open this menue on the sreen.
Unsolicited result code
^SSTN: <254>
Reference
Siemens
Note