Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル
AT Command Set
MC35_ATC_01_V04.00
Page 89 of 238
02.04.2002
Reference
GSM 07.07
Unsolicited Result Code:
+CIEV: <desc>,<value>
Note
Only the indicators which are registered (see AT+CIND command), will be re-
ported if CMER is enabled.
While the ME is in online data mode, and CMER’s <mode> equals to 3, no URC
will be displayed on the TE, but they will be available after ‘+++’ has been entered.
After CMER has been switched on, URCs for all registered indicators with their
default value, will be presented to the TE.
ported if CMER is enabled.
While the ME is in online data mode, and CMER’s <mode> equals to 3, no URC
will be displayed on the TE, but they will be available after ‘+++’ has been entered.
After CMER has been switched on, URCs for all registered indicators with their
default value, will be presented to the TE.
4.26 AT+CMEE Report mobile equipment error
Test command
AT+CMEE=?
Response
+CMEE: (list of supported <n>s
) OK
Parameter
See write command
Read command
AT+CMEE?
Response
+CMEE: <n> OK
Parameter
See write command
Write command
AT+CMEE=<n>
This command controls the presentation of the result codes +CME ERROR:
<err> and CMS:<err> that indicate errors relating to ME functionality.
<err> and CMS:<err> that indicate errors relating to ME functionality.
When you power down or reset the ME with AT+CFUN=1,1 the setting will be re-
set to its default. The levels 1 or 2 need to be selected every time you reboot the
ME, or may be included, for permanent use, in the user profile saved with AT&W.
set to its default. The levels 1 or 2 need to be selected every time you reboot the
ME, or may be included, for permanent use, in the user profile saved with AT&W.
Response
OK
Parameter
<n>
0 disable result code (only 'ERROR' will be displayed)
1 enable result code and use numeric values
2 enable result code and use verbose values
1 enable result code and use numeric values
2 enable result code and use verbose values
Example
To obtain enhanced error messages it is recommended to choose <n>=2.
AT+CMEE=2
OK
AT+CMEE=2
OK
Reference
GSM 07.07
Note
• The possible error result codes are listed in chapter 9
• In multiplex mode (see “AT+CMUX Enter multiplex mode”, pg. 91) the setting
applies only to the logical channel where selected. The setting on the other
channels may differ.
channels may differ.