Sharp Water Dispenser PN-L601B ユーザーズマニュアル

34

E

You can customize various settings of this software.

The settings are the same in both whiteboard mode and overlay mode. However, the contents of the screen will vary depending 

on which mode is started.

(5)

(13)*

1 

(1)

(2)

(3)

(4)

(6)*

1

(7)*

1

(8)
(9)

(10)*

1 

(11)*

2

(14)*

1 

(15)*

3 

(16)

(17)

(12)

*1 Only whiteboard mode can be selected.

*2 For “Print All”, only whiteboard mode can be selected.

*3 Only overlay mode can be selected.

Set the following default settings that are applied when the Pen Software is started: the color and thickness of “Pen 1” to “Pen 
3” and “Figure pen”, the size of “Eraser”, the font, size, style and color of “Text”, the shape, fill color, and line color/thickness 
of “Figure”, and line color/thickness/type of “Line/Arrow”.

Set whether or not you can draw with your finger when the pen function is selected (Page 14).
If a PN-L series interactive display is not connected when the pen software is started, this function cannot be used. The 
setting is fixed to “Both touch pen and finger”.

To use this function, select this to have the pen automatically switch to the eraser when the screen is touched with the eraser 
or your finger in pen mode. Set the eraser size that is applied in “Eraser Size”.

•  The area you touch (or cover) 

: When using an eraser or other object and the area of contact on the screen is at 

least 1-9/16 inch (4 cm) x 1-9/16 inch (4 cm), erase the area of contact.

•  The selected size in Eraser Palette  : Erase with the selected eraser size regardless of the amount of contact on the screen.
If a PN-L series interactive display is not connected when the pen software is started, this function cannot be used.

TIPS

•  To use this function with a PN-L series interactive display, select the touch panel driver “Properties”, and configure the 

settings on the “Operation Setting” tab as shown below. For information on the touch panel driver, see the Touch Panel 
Driver Operation Manual.
- Set “Input Mode Setting” to “Standard”. If set to other than “Standard”, the pen/eraser auto switching function cannot be 

used.

- If you have selected “The area you touch (or cover)”, set “Detect Eraser Area” to “Enable”.

Select this to have the palettes of “Pen 1” to “Pen 3” and “Eraser” close when a pattern is selected from a palette.
If the checkmark is removed,   must be clicked to close the palette.