SharkRack KVM-8 ユーザーズマニュアル
KVM-8 Installer/User Guide
36
37
Characters on screen do
not match keyboard input
not match keyboard input
Try changing the keyboard scan set for that channel
by using the keyboard command sequence <Kn>. (For
more information, see the “Basic Operations” chapter.) If
the problem persists, call SharkRack Technical Support.
by using the keyboard command sequence <Kn>. (For
more information, see the “Basic Operations” chapter.) If
the problem persists, call SharkRack Technical Support.
No keyboard, video or
mouse on the expansion
unit; the base unit is
functioning properly
mouse on the expansion
unit; the base unit is
functioning properly
Verify that the cable connecting the two units together
is correctly connected on both ends. (For additional
information, see the “Installation” chapter.) If the problem
persists, contact SharkRack Technical Support.
is correctly connected on both ends. (For additional
information, see the “Installation” chapter.) If the problem
persists, contact SharkRack Technical Support.
OSD menu does not display Verify that you are pressing the Control key twice
within one second. If the problem persists, contact
SharkRack Technical Support.
Verify that the channel is powered. Check the address
configured in OSD. If the computer is powered and the
address is correct, call SharkRack Technical Support.
SharkRack Technical Support.
Verify that the channel is powered. Check the address
configured in OSD. If the computer is powered and the
address is correct, call SharkRack Technical Support.
Unable to change channels
using OSD
using OSD
Verify that the channel is powered. Check the address
configured in OSD. If the computer is powered and the
address is correct, call SharkRack Technical Support.
configured in OSD. If the computer is powered and the
address is correct, call SharkRack Technical Support.
Administrator password
is forgotten
is forgotten
Call SharkRack Technical Support at (877) 427-5722.
User password is forgotten
Contact your system administrator.
General Keyboard/Video
Problems
Problems
If the building has 3-phase AC power, ensure that the
computer, the KVM Switch and the monitor are on the
same phase. Best results are obtained when they are
on the same circuit.
Use only SharkRack supplied cable. Warranties do not
apply to damage resulting from user supplied cable.
Do not use a 2-wire extension cord in any SharkRack
product configuration.
Test AC outlets at computer, KVM Switch and monitor
for proper polarity and grounding.
Use only with grounded outlets at the computer, KVM
Switch and monitor. When using a backup power supply
(UPS), power the computer, KVM Switch and the
monitor off the supply.
computer, the KVM Switch and the monitor are on the
same phase. Best results are obtained when they are
on the same circuit.
Use only SharkRack supplied cable. Warranties do not
apply to damage resulting from user supplied cable.
Do not use a 2-wire extension cord in any SharkRack
product configuration.
Test AC outlets at computer, KVM Switch and monitor
for proper polarity and grounding.
Use only with grounded outlets at the computer, KVM
Switch and monitor. When using a backup power supply
(UPS), power the computer, KVM Switch and the
monitor off the supply.
Poor Video Quality at
Remote User
Remote User
Verify that the length of Category 5 cable between
the KVM Switch and Remote User is 500 ft or less.
Make sure the video connectors at both ends are firmly
seated. Make sure that the Category 5 connectors are
properly inserted. Make sure that the modular plugs on
the Category 5 cable were properly crimped onto the
cable.
the KVM Switch and Remote User is 500 ft or less.
Make sure the video connectors at both ends are firmly
seated. Make sure that the Category 5 connectors are
properly inserted. Make sure that the modular plugs on
the Category 5 cable were properly crimped onto the
cable.
Symptom
Action