Rocketfish RF-TVMLPT01 プリント

6907-002013<00> 

10-0361 

Caution: Do not use this product for any purpose not explicitly specified by Rocketfish. Improper installation 

may cause property damage or personal injury. If you do not understand these directions, or have doubts 

about the safety of the installation, contact Customer Service or call a qualified contractor. Rocketfish is not 

responsible for damage or injury caused by incorrect installation or use. The weight of your TV must not 

exceed 50 lb (22.7 kg). The wall must be capable of supporting five times the weight of the TV and wall 

mount combined. 

This product contains small items that could be a choking hazard if swallowed. Keep these items away from 

young children!

Visit www.rocketfishproducts.com for details.

www.rocketfishproducts.com

For customer service, call:

© 2010 BBY Solutions, Inc., All Rights Reserved.

Distributed by Best Buy Purchasing, LLC 7601 Penn Avenue South, Richfield, MN USA 55423-3645

Best Buy Imports, S. de R.L. de C.V. Av. Santa Fe 485, Segundo Piso, Colonia Cruz Manca, Programa Parcial de Desarrollo

Santa Fe, Delegación Cuajimalpa, Distrito Federal, México 05349

ROCKETFISH is a trademark of BBY Solutions, Inc. Registered in some countries. All other products and brand names are

trademarks of their respective owners.

Caution: Avoid potential injuries or property damage!

DO NOT over-tighten the lag bolts.

Any material covering the wall must not exceed 5/8 in. (16mm).

Caution: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts.

Any material covering the wall must not exceed 5/8 in. (16mm).

a. Locate the stud. Verify the  center of the stud with    

     an awl or thin nail or use an  

     edge-to-edge stud finder.
b. Level the wall plate (B)   

     and mark  the hole   

     locations.
c. Drill the pilot holes  

     as illustrated.
d. Align the wall plate  

    with the pilot holes,  

    insert the lag bolts       

    (I) through the holes    

    in the wall plate, then     

    tighten the lag bolts

    with a socket wrench   

     

    only until they are pulled      

    firmly against the wall   

    plate.

     a.Slide the TV/wall bracket assembly down over the  

         tabs on the wall plate (B), then tighten the locking      

         screw with the hex key (H). 

a. Level the wall plate (B) and mark    

     the hole locations.

b. Drill the pilot holes as illustrated.

c.  Insert the concrete wall anchors    

     (J) into the pilot holes and use a      

     hammer to make sure that the    

     anchors are seated flush with the   

    

 

concrete surface.

d. Align the wall plate with the  

 

     anchors, insert the lag bolts (I)    

     through the holes in the wall  

 

     plate, then tighten the lag bolts    

     with the socket wrench only until      

    they are pulled firmly against the    

    wall plate. 

You can adjust the tilt angle of the screen ± 12°.

If necessary, the tilt tension can be adjusted by tightening or

loosening the tension knob with either the hex key (H) or by 

hand.

Caution: To prevent property damage 

or personal injury, never drill into 

mortar  between blocks.