RGB Spectrum Digital Recording and Streaming System DGy 201x ユーザーズマニュアル

. . . . .

TiMingLIST

[<1..160> [<1..160>]] | 
[ACTIVE]

Displays the list of saved input and output timings. 
If two numeric arguments are supplied, displays all 
entries in the range. ACTIVE, displays only the 
active timings.

TiMingLISTCLEAR

(none)

Deletes all user entries from the Timing List. 

TiMingLISTLOAD

<100 ...160> <name> 
<hfp> <hs> <hbp> 
<hact> <vfp> <vs> 
<vbp> <vact> <hfreq> 
<sync> <hpol> <vpol> 
<il>

This command is used to create and save a user 
timing set to the Timing List. 

User defined entries may be saved to the list using 
slots 100 - 160. Timing slots 1 - 99 are reserved for 
factory defined timing settings. 

The name parameter is a name that is used to 
identify the timing set (for example mytiming3).

hfp - width of the horizontal front porch (pixels)

hs - width of the horizontal sync pulse (pixels)

hbp - width of horizontal back porch (pixels)

hact - width of the active picture area (pixels)

vfp - width of the vertical front porch (pixels)

vs - width of the vertical sync pulse (pixels)

vbp - width of vertical back porch (pixels)

vact - height of the active picture area (pixels)

hfreq - horizontal frequency (Hz)

sync - type of sync signal (analog 3, 4 or 5 wire)

hpol - polarity of horizontal sync pulse (0=negative, 

1=positive)

vpol - polarity of vertical sync pulse (0= negative, 

1=positive)

il - interlace (0 = non interlace, 1 = interlace)