PowerMax DE5450 ユーザーズマニュアル

4

DE5450

  D .  Remove the screw that secures the lid (see Figure 3),

swing the lid up and pull it away. You now have access
to the battery holder (see Figure 4).

  E .  Pull out the battery holder and check that the battery

type selection jumper is positioned in accordance with
the type of batteries being installed (see Figure 4). For
alkaline (dry) cells, the jumper should be mounted on
the two lower pins. For Nickel Cadmium (rechargeable)
cells - on the two upper pins.

F. Insert all 6 battery cells - 3 at the top and 3 at the bottom.

Make sure that the flat (–) end of each cell is pressed

against a circular spring and the capped (+) end of each

cell is pressed against a flat contact.

G. Put the battery holder back in, re-mount the battery

compartment lid and re-attach it using the screw.

(due to lack of AC or lack of telephone line connection).

H. Put back the battery area cover - insert the angled legs

at the left edge into their holes and then press the right

edge of the cover against the cabinet surface until the

catches click into place.

3.3 Programming  

It pays off to plan ahead - use the tables in appendices A

and B at the end of this guide to register the intended

location of each detector, the holder and assignment of

each transmitter and the control plan for the X-10 units.
Gather up all transmitters and detectors used in the

system and mark each one in accordance with your

deployment plan.
Program the system now as instructed in the PowerMax

3.4 Mounting the Bracket

A notable advantage of the PowerMax is that the unit can

be mounted without having to open its cabinet. All

connectors and terminals are accessible through a

rectangular opening at the rear, and wiring channels are

provided across the rear of the cabinet. Quick mounting of

the PowerMax is possible by virtue of a special bracket

and a unique mechanical coupling / locking mechanism.
The control panel comes with the bracket in place at the

rear. The bracket lock at the front (see Figure 5) is left

open. Since a catch at the lower end of the bracket is

trapped within the cabinet, a special plastic key (supplied

in the kit) must be used to release it  - see Figures 6 & 7.

Figure 7. Detaching the Bracket  

Having detached the bracket successfully, put it on a desk
and observe its design - see Figure 8 for identification of
its various parts.
The upper and lower mounting holes are intended for
regular attachment to the wall with screws and anchors.
A special “ring and cam” piece is connected to the bottom
leg of the bracket by 3 breakable plastic joints. A large
plastic washer supplied with the bracket must be inserted
into the ring to allow fastening the ring to the wall. With the
washer in place, a fourth screw can be used to secure the
ring and cam piece to the wall.
Once the control panel is mounted in place, the cam

enters a slot in the control panel’s rear part and maintains

the built in tamper switch pressed. Separating the control