Polycom 1725-36082-001 ユーザーズマニュアル

 

Nortel: WLAN Security Switch 2300 Series with AP-2330 

PN: 1725-36082-001_G.doc 

7

Configuring a New WLAN Security Switch 
Starting from Factory Defaults 

1.  Using the supplied DB-9 male to DB-9 female standard RS-232 

cable, connect the WLAN Security Switch to the serial port of a 
terminal or PC. 

2.  Run a terminal emulation program (such as HyperTerminal) or 

use a VT-100 terminal with the following configuration: 

Bits per second: 

9600 

Data bits: 

8 

Parity: None 

Stop bits: 

1 

Flow control: 

None 

3.  Power-on the WLAN Security Switch. The status of the boot 

process will appear in the console as the switch is powering up. 
Once the switch is operational you will be presented with a login 
prompt. 

4.  A Quick Start Wizard provides for an easy means to perform 

initial WLAN Security Switch setup and configuration. Refer to 
the WLAN Security Switch 2300 Series Quick Start Guide found at 
Nortel’s Technical Support site. This document contains a detailed 
explanation of using the Startup Wizard: 

5.  Once the WLAN Security Switch has been configured via the 

Quick Start Wizard, the remaining configuration can be 
performed using command line interface (CLI), Web View or 
WLAN Management Software (WMS). Configuration examples 
will be provided for both CLI and WMS. 

6.  If necessary, the WLAN Security Switch may be reset to factory 

defaults. To reset the WLAN Security Switch to factory defaults, 
you must issue the “clear boot config” command via the console.